Dulux® AcraStone® Grip Primer is part of a coating system to create a seamless and natural looking Microcement finish. The system is suitable for walls and floors and can be used in a wide range of environments including residential and commercial zones. Suitable environments include bathrooms, showers and other wet areas which are not submerged, flooring around the home, retail areas such as shop floors and restaurants and can be used in high traffic areas such as hotel foyers. The Grip Primer is suitable for application on difficult or non-absorbent substrates such as bathroom tiles and can also be used on other standard substrates such as concrete, AAC and plasterboard.
Re-coat
4 hours
Cleaning materials
Water
Application Tools
Brush, Roller
This product data sheet should be read in conjunction with the Dulux specification.
Take suitable safety precautions while preparing your surface or sanding a previously coat/ coated, including wearing an appropriate respiratory mask.
To ensure colour uniformity and for optimum performance, Dulux recommend a full coating system including two to three topcoats.
For all systems, Base Coat should be tinted in accordance with Tint Guide to the specified topcoat colour (or a colour as close as possible to the specified colour as product and Acratex tint rules allow).
Ensure tint cups are mixed well using a power mixer.
IMPORTANT: Not all colours are suitable for exterior use.
Ensure that you have adequate tinted stock to complete the job in one application.
All material must be thoroughly cross-mix to ensure tint uniformity.
It is recommended to hold a volume of finish material for future maintenance touch-ups.
Practical spreading rates will vary from quoted theoretical figures depending on substrate porosity, surface roughness, overspray losses, application methods and environmental conditions (e.g. wind).
Do not apply paint if Relative Humidity is above 85% or temperature is within 3°C of Dew Point.
Do not apply if the surface temperature is greater than 40°C or below 10°C, or likely to fall below 10°C during the application or drying period.
Dry times apply to a single coat at recommended spread rate and at 25°C and 50% Relative Humidity
Allow longer times under cool, moist, or still conditions and or when applied at high film builds.
Exterior applications protect from dew, rain and frost for 48 hours when apply at the recommended spread rate.
Avoid application in hot, windy conditions or on hot surfaces cool the surface by hosing with water and paint the cool damp surface.
The coating system should be cleaned on a regular basis. This will help maintain your overall aesthetic appearance and preserve your Dulux AcraStone coating system.
Surface Preparation
Apply on clean dry surfaces, free of oil, grease, mould, dust or any other element that may affect the adhesion of the system. Clean the surface with degreasing product. Make sure that tiles are well fixed and not detaching.
Do not apply the product where there is rising damp.
Ensure moisture content is less than 10% as measured with standard moisture meter.
Refer to specifications for full surface preparation detail.
For wet areas, the AcraStone system must be applied in conjunction with a waterproofing membrane that complies with AS 3740:2021 Waterproofing of domestic wet areas.
Application Procedure and Equipment
The Dulux AcraStone range of products are designed for application by professional applicators. Applicators must have completed a 'Microcement' application course and hold a current Dulux Trade account.
Apply using a brush or a standard 10mm to 20mm nap roller.
Thoroughly mix before use to ensure no settling of material.
Brush and roll at the same time to avoid picture framing.
