Dulux
Powdercoat Renew Pearl White Gloss
Dulux
Powdercoat Renew Pearl White Gloss
Powdercoat Renew Pearl White Gloss
Dulux Powdercoat Renew is a professional recoating system specifically designed for powder-coated surfaces. Suitable for touch-up, repair, refresh and renewal applications, it delivers colour confidence, durable performance and longer lasting colour. Matched to Dulux Powdercoat standards and formulated with advanced siliconised acrylic technology, Powdercoat Renew helps maintain the appearance of powder-coated assets for longer.
Touch Dry
10 minutes
Re-coat
1 hour
Cleaning materials
General Purpose Thinner
Application Tools
Aerosol spray
If bare metal is visable Dulux Metalshield Etch Primer must be used prior to applying Dulux Powdercoat Renew
Care, Maintenance & Cleaning
To help maintain the appearance and performance of surfaces repaired with Dulux Powdercoat Renew, regularly clean the coated surface using a soft cloth or sponge and a solution of mild detergent and clean water. Rinse thoroughly to remove any residue and dry with a clean cloth where practical. Avoid abrasive cleaners, scouring pads, solvents, or harsh chemical cleaners, as these may damage the coating and affect gloss and colour retention. Promptly remove dirt, salt deposits, bird droppings, and other contaminants, particularly in coastal or industrial environments where increased maintenance may be required. Regular inspection and cleaning will help preserve the finish and extend the service life of the repaired area.
The surface must be clean and dry, free from grease, rust and dirt. Lightly sand powder coated surface with 600 grit sandpaper. Apply Dulux Metalshield® Etch Primer if bare metal is visible. Clean with wax and grease remover.
BEFORE SPRAYING: Shake can for at least two minutes after first rattle. Avoid spraying in temperatures less than 15°C or high humidity.
APPLICATION: To ensure colour accuracy and compatibility, test spray on an inconspicuous area. FOR TOUCH UP (Areas under 5cm × 5cm): Hold the can upright 20–25cm from the surface. Apply several light coats directly to the damaged area using very small strokes. Can be re-coated after 10 mins.
FOR RENEWING (Areas over 5cm × 5cm): Hold the can upright 20–25cm from the surface. Use smooth, even strokes parallel to the surface. Apply several light coats rather than 1 heavy coat to avoid runs and sags. (Apply minimum 2–3 coats). Number of coats required will depend on colour. Can be re coated after 10 mins. Dry times at 25°C.
SPRAYING SPECIAL EFFECTS (METALLICS AND PEARLS)
Apply multiple light, even coats maintaining a consistent distance of 20 to 25 cm from the surface. Keep each pass overlapping by approximately 50% to promote uniform metallic or pearl orientation and avoid patchiness. Allow 2-5 minutes between coats. After achieving coverage, apply a light "dry coat" by slightly increasing the spray distance and moving the can more quickly across the surface. This allows the metallic or pearl particles to settle more evenly, helping to minimise mottling, striping, and patchiness while enhancing colour uniformity and effect.
AFTER SPRAYING: Prevent blocking by turning can upside down and spraying until clear gas emerges. Wipe the nozzle clean. Clean up overspray while still wet with general purpose thinner.
Spray unwanted paint onto newspaper, allow to dry and dispose of remaining contents/container in accordance with local, regional, national and international regulations.
If can becomes rusted or damaged dispose of carefully – obtain instructions from our website or 24hr Emergency Response Number.