Berger Gold Label® Full Gloss Enamel is a high quality interior/exterior full gloss oil-based enamel with high opacity and very good durability.
Touch Dry
6 Hours
Cleaning materials
Thinner
Application Tools
Air Spray, Airless Spray, Brush, Roller
All preparation and painting must conform to AS2311: The Painting of Buildings.
Check adhesion of old paint by cutting through the film with a razor blade or trimming knife, press cellulose tape firmly across the cut and rip it off. If the old paint comes off with the tape it should be removed before repainting. Do not apply if the surface temperature is below 10C or conditions indicate it will fall below 10C during the drying period. Do not apply externally when weather is doubtful, or late in afternoon during winter, as frost, rain or dew on the uncured film may result in complete loss of gloss or patchiness, and impair durability. All enamels will yellow with age. This can be accelerated by darkness, heat and exposure to ammonia from freshly painted acrylic paints and some cleaning agents, particularly during the drying period.
Remove grease, oil, etc. by washing with a commercial paint cleaner. Thoroughly rinse and allow to dry. Acid and alkali contamination should be removed by thorough rinsing with clean water. Efflorescence or mould on plaster, masonry or timber surfaces must be treated. Rust, millscale, oxide deposits, loose or flaking paint or other foreign material on metal surfaces should be removed in accordance with the requirements of the chosen system. Apply primer, sealer or undercoat as required.
Brush, roller, conventional or airless spray
Stir contents thoroughly before and during use with a broad flat stirrer, using an upward lifting action.
Brush/Roller
Apply one or two full coats to the prepared surface. Reduce if necessary with up to 50ml per litre of mineral turpentine.
Suitable for application by all standard spray equipment. If necessary thin with up to 100ml per litre Spraying Thinner to aid atomisation.
