Berger Everlast creates a beautiful and washable finish that is built to last in your home. With a low VOC and low odour formulation, Berger Everlast is Breathe Easy® allowing you to move back into your home sooner. Its smooth finish is tough, hard wearing and designed to last.
Touch Dry
30 mins
Cleaning materials
Water
Application Tools
Air Spray, Airless Spray, Brush, Roller
All preparation and painting must conform to AS2311: The Painting of Buildings. Do not paint at temperatures below 10°C or when the temperature of surface may fall below 10°C during the drying period. Avoid exposure to steam and condensation for 48 hours after application. Although film is dry to touch in 30 minutes, allow 7 days for film to fully cure before cleaning with a cloth, or soft brush wet with detergent solution.
Tinted colours. Ensure that paint is thoroughly shaken and stirred immediately after addition of tinter to can and again before use. Darker colours will show more signs of marking and scuffing than lighter colours - if you are considering using a dark colour in a high traffic area you may want to consider a higher sheen level or the use of a protective clear coat.
All surfaces must be thoroughly cleaned and free of all loose dirt, dust, grease, loose or flaking paint, and loose surface plaster. Efflorescence or mould on masonry or concrete surfaces must be treated. Flatten gloss surfaces by thoroughly sanding and wipe clean with a damp cloth, then apply primer, sealer or undercoat as required. Do not sand between coats.
*Some colours may require more than the recommended number of coats to achieve full opacity.
Brush, roller and spray.
Stir contents thoroughly before and during use with a broad flat stirrer using an upward lifting action.
Brush/Roller: Use medium nap roller. Pre wet brushes and roller with water before commencing application. Avoid excessive brushing or rolling back into the paint which has been drying for more than 3 minutes. Thinning not usually required. Under hot conditions upto 50ml per litre of water may be used.
Airless/Conventional Spray:
Suitable for application by all standard spray equipment. If necessary, to aid atomisation, up to 100 ml/litre water may be added for conventional spray or up to 30 ml/litre of water for airless spray.
