Berger Gold Label® Acrylic Sealer Undercoat is an interior water based acrylic sealer undercoat especially formulated for application prior to the use of either oil based or water based topcoats.
Touch Dry
20 Minutes
Cleaning materials
Water
Application Tools
Air Spray, Airless Spray, Brush, Roller
All preparation and painting must conform to AS2311: The Painting of Buildings.
Do not overspread or exceed 12.0 square metres per litre per coat. In hot weather, rinse brush every half hour or use two and keep one standing in water. Do not apply if temperature is under 10C, or when temperature of surface may fall below 10C during the drying period, otherwise film formation will not be complete and a fall-off in properties will result.
All surfaces must be thoroughly dry, clean and free of all loose dirt, grease, mould, mildew and wax, surface chalk and loose or flaking paint. Sand smooth, dust down, fill and prime in accordance with the requirements of the chosen system.
Interior masonry, timber and paper-faced plasterboard
Wipe/dust down surface, apply 1 coat of Berger Gold Label Acrylic Sealer Undercoat. For set plaster use Berger Gold Label Oil Based Undercoat.
Brush, roller, conventional or airless spray
Stir contents thoroughly before and during use with a broad flat stirrer, using an upward lifting action.
Brush/Roller
Rinse brush or roller in water before starting and use while still slightly damp. Apply two full even coats direct from the container. Under hot or windy conditions or on very absorbent surfaces, up to 100 ml of clean water may be added per litre to assist application. Avoid excessive brushing or rolling back into paint which has been drying some minutes.
Airless/Conventional Spray
Suitable for application by all standard spray equipment. If necessary thin with up to 100ml per litre of water to aid atomisation.
