Dulux Prepcoat Acrylic Sealer Undercoat is low VOC with excellent hiding power for use on interior surfaces including plasterboard and textured surfaces.
Touch Dry
20 minutes
Re-coat
2 hours
Cleaning materials
Water
Application Tools
Brush, Roller, Spray
All preparation and painting must conform to AS2311: The Painting of Buildings.
Do not apply when the temperature is 10C or under or likely to fall below 10C during the drying period.
Tinter if added should be shaken and stirred in immediately and thoroughly.
Do not overspread, or exceed the recommended rate of 16 square metres per litre.
Previously painted surfaces: Thoroughly clean all surfaces free of loose dust, surface chalk, grease, mould, mildew, wax and loose or flaking paint. Wash with sugar soap. Treat mould contaminated areas with antimould. Rinse with clean water. Fill nail holes, imperfections and cracks with a suitable filler, sand and dust off. For use on paperfaced plasterboard and masonry. On bare set plaster, use 1 coat of DULUX Sealer Binder.
Brush, roller, conventional and airless spray.
Stir contents thoroughly before and during use with a broad, flat stirrer using an upward lifting action.
Brush/Roller: Pre-wet brushes and roller with water prior to use. A short or medium nap roller will give most uniform appearance. Apply a full even coat and finish by light parallel strokes with a practically dry roller.
Conventional/Airless Spray: Suitable for application by all standard spray equipment.
