HADRIAN® CONTRACTOR Plaster Sealer is an interior water based acrylic sealer undercoat especially formulated for application prior to the use of either oil based or water based topcoats.
Touch Dry
20 Minutes
Cleaning materials
Water
Application Tools
Air Spray, Airless Spray, Brush, Roller
All preparation and painting must conform to AS2311: The Painting of Buildings.
Do not overspread or exceed 14.0 square metres per litre per coat. In hot weather, rinse brush every half hour or use two and keep one standing in water. Do not apply if temperature is under 10°C, or when temperature of surface may fall below 10°C during the drying period, otherwise film formation will not be complete and a fall-off in properties will result.
Hadrian Contractor Plaster Sealer is not recommended for set plaster. Dulux Sealer Binder is recommended as a barrier coat for the set plaster applications.
All surfaces must be thoroughly dry, clean and free of all loose dirt, grease, mould, mildew and wax, surface chalk and loose or flaking paint. Sand smooth, dust down, fill and prime in accordance with the requirements of the chosen system.
Brush, roller, conventional or airless spray.
Stir contents thoroughly before and during use with a broad flat stirrer, using an upward lifting action.
Brush/Roller: Rinse brush or roller in water before starting and use while still slightly damp. Apply two full even coats direct from the container. Under hot or windy conditions or on very absorbent surfaces, up to 100 ml of clean water may be added per litre to assist application. Avoid excessive brushing or rolling back into paint which has been drying some minutes.
Airless/Conventional spray: Suitable for application by all standard spray equipment. If necessary thin with up to 100 ml of water per litre to aid atomisation.
