Luxafloor
CP Curing Polyurethane
Luxafloor
CP Curing Polyurethane
CP Curing Polyurethane
LUXAFLOOR® CP is a clear, colourless, moisture curing, aliphatic (non-yellowing), clear urethane coating for brush, or roller application. A high performance clear finish coat for natural wooden floors and ground concrete.When applied to diamond ground concrete, LUXAFLOOR® CP enhances the aggregate particles in the floor, imparting a contemporary “polished concrete” look that also protects against staining from spills.When LUXAFLOOR® CP Low Sheen is applied as the final coat over LUXAFLOOR® CP Gloss, it imparts an elegant low sheen finish to the floor.
Cleaning materials
Dulux® Urethane Thinner
Application Tools
Brush, Roller
This is an industrial product designed for use by experienced Protective Coating applicators. Where conditions may require variation from the recommendations on this Product Data Sheet contact your nearest Dulux® Consultant for advice prior to painting.
Note – Rubber-tyred vehicles, particularly those using new high-performance car tyres, may cause yellowing or staining on floor coatings. The rubber can contain materials that will migrate into the surface coating and cause this effect. This is dependent on the composition and age of the tyre and may affect all coatings to a greater or lesser extent.
Refer to our tech note to find out more about tyre staining and how it can be managed.
Dulux Protective Coatings cannot guarantee the resistance of our coatings to this effect and will take no responsibility where tyre staining occurs.
Concrete: Concrete should be at least 28 days old before coating. Remove all laitance, curing compounds, oil, grease and other surface contaminants. Diamond grind, track or light shot-blast concrete floors to remove laitance and provide a suitable profile. Remove all dust by vacuum cleaning. Fill any large cracks or voids with a suitable epoxy filler or surfacer recommended by your local Protective Coatings Representative.
Shake can before use. Decant sufficient for immediate use into a roller tray or working pot. Seal original container to prevent moisture exposure. Decant only that sufficient for 30 minutes use and do not return unused product to original container.
Apply by floor brush or mohair roller. Sand lightly between coats to remove defects. Thinning not normally recommended. When brushing and rolling additional coats may be required to attain the specified thickness.