This is an industrial product designed for use by experienced Protective Coating applicators. Where conditions may require variation from the recommendations on this Product Data Sheet contact your nearest Dulux® Consultant for advice prior to painting.
- Do not apply in conditions outside the parameters stated in this document without the written consent of Dulux® Australia. Freshly mixed material must not be added to material that has been mixed for some time. The rate of cure is dependent upon temperature and film build.
- Do not apply at temperatures below 5°C.
- Do not apply at relative humidity above 85% or when the surface is less than 3°C above the dewpoint.
- Ensure that you read and understand the safety precautions on the Material Safety Data Sheets for the two components before using.
- Under no circumstances should water or non-specified thinner be allowed to contaminate the product.
- Do not add tinter to this product as this may compromise the products ability to cure.
Note – Rubber-tyred vehicles, particularly those using new high-performance car tyres, may cause yellowing or staining on floor coatings. The rubber can contain materials that will migrate into the surface coating and cause this effect. This is dependent on the composition and age of the tyre and may affect all coatings to a greater or lesser extent.
Refer to our tech note (https://www.duluxprotectivecoatings.com.au/media/1542/139-concrete-floors-tyre
staining.pdf) to find out more about tyre staining and how it can be managed.
Dulux Protective Coatings cannot guarantee the resistance of our coatings to this effect and will take no responsibility where tyre staining occurs.