Intergrain Charred Black Timber Stain is an exceptionally durable timber stain that provides high performance protection against the effects of UV and weathering. This water based, penetrating formula gives an incredibly deep black colour, replicating the appearance of charred timber. For use on cladding, screening and other vertical timber surfaces, Intergrain Charred Black Timber Stain is guaranteed to never peel, flake or blister.* Note: Intergrain Charred Black Timber Stain is not suitable for walk-on surfaces.
Cleaning materials
Water
Application Tools
Spray, Brush, Pad
Intergrain Charred Black Timber Stain is suitable for use on cladding, vertical screens, fences, doors, railings and other vertical timber surfaces. It is not suitable for walk-on surfaces.
New bare timber
Sand timber to a uniform, smooth surface. Ensure the timber is dry and free from all dirt, dust, wax and oils. Clean oily timbers, such as Brushbox, Spotted Gum, Cypress or Tallowwood with Intergrain UltraPrep Tannin and Oil Remover followed by Intergrain UltraPrep Timber Cleaner following directions on pack and allow to dry.
Previously painted, stained, oiled or varnished timber
All paints and coatings that seal the surface must be thoroughly removed back to bare timber. To remove coating sand, or use a combination of Intergrain Liquid 8™ Timber Stripper and sanding. Remove all sanding dust or paint stripper residue. Weathered, grey or mouldy timber Treat mould first with Intergrain UltraPrep Mould Killer following by a thorough clean wit Intergrain UltraPrep Timber Cleaner following the directions on the packs and allow to dry. Sand timber (where required) back to a fresh surface, and remove sanding dust with a clean, damp cloth.
Composite cladding substrates
Sand, remove sanding dust, then check for adhesion by applying Intergrain Charred Black Timber Stain Matt to a test area, approximately 250mm x 250mm. Allow to dry for twelve hours then firmly press a strip of sticky tape over the coated section and rip off quickly. If the coating is removed, do not proceed as the surface is not suitable. Nail holes and surface defects should be filled with Intergrain Woodblend™ Wood Filler prior to top coating as required.
Application Procedure: Ensure surface is clean and dry before coating. Stir Intergrain Industrial Solid Timber Stain thoroughly before and during use with a flat blade stirrer. It is recommended to test in a small area to ensure satisfaction with the colour and finish prior to staining the whole project. Ensure to apply minimum 2 coats for the best indication of final colour and finish. Apply at a coverage rate of 10m2/L. Do not overspread or apply thinly as insufficient film thickness will compromise performance and durability. When coating large areas, work in sections, apply long strokes and use natural breaks in the boards as stopping points. Allow to dry, then apply a second coat.
